INTELLIGENT PARKING ASSIST SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT AUXILIARY BATTERY VOLTAGE |
Measure the auxiliary battery voltage with the power switch off.
| |||||
| 3.CHECK NAVIGATION SYSTEM |
Refer to the navigation system (Click here).
| Result | Proceed to |
| Navigation system is normal | A |
| Navigation system is abnormal | B |
|
| ||||
| |||||
| 4.CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).
| Result | Proceed to |
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
|
| ||||
| |||||
| 5.CHECK FOR DTC* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTC (Click here).
Recheck for DTCs. Try to prompt the DTC by simulating the original activity that the DTC suggests.
| Result | Proceed to |
| DTCs are output | A |
| DTCs are not output | B |
|
| ||||
| |||||
| 6.DIAGNOSTIC TROUBLE CODE CHART* |
Refer to Diagnostic Trouble Code Chart (Click here).
|
| ||||
|---|---|---|---|---|---|
| 7.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 8.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Data List / Active Test (Click here)
Terminals of ECU (Click here)
| |||||
| 9.CIRCUIT INSPECTION |
| |||||
| 10.ADJUST, REPAIR OR REPLACE |
| |||||
| 11.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|