Home › Engine / Hybrid System › 2ZR-FXE COOLING › EXHAUST HEAT RECIRCULATION SYSTEM

EXHAUST HEAT RECIRCULATION SYSTEM > Exhaust Heat Recirculation System Circuit

for Preparation Click here


DESCRIPTION

In the exhaust heat recirculation system, coolant is warmed up using conventionally wasted exhaust gas heat to accelerate engine warm-up time, enhancing fuel efficiency and heater performance.
The heat recirculator is positioned in the front exhaust pipe assembly after the catalyst. Coolant from the engine flows around the heat recirculator and then returns to the engine. If the engine is started while the engine is cold, the exhaust pipe gas control actuator rod is contracted and the exhaust flow control valve is closed, routing the exhaust gas around the heat recirculator to warm up the coolant.
After the engine coolant temperature rises and the engine has warmed up, the heat of the coolant expands the thermostat and the exhaust pipe gas control actuator rod extends. This opens the exhaust flow control valve to switch to the normal exhaust gas path.
The exhaust flow control valve can also be opened by exhaust gas pressure to prevent insufficient acceleration performance when the engine is cold. In addition, to monitor the engine coolant temperature, a engine coolant temperature sensor (for exhaust heat recirculation system) is provided between the engine and the heat recirculator. The engine coolant temperature sensor (for exhaust heat recirculation system) has a built-in thermistor with a resistance that varies according to the temperature of the engine coolant. When the engine coolant temperature becomes low, the resistance of the thermistor increases. When the temperature becomes high, the resistance drops. These variations in resistance are transmitted to the No. 3 meter circuit plate as voltage changes. If the engine coolant temperature is excessively high (overheating), the water temperature indicator light in the No. 3 meter circuit plate illuminate to inform the driver of the malfunction.

A215947E01


WIRING DIAGRAM

Refer to System Diagram (Click here).

INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - METER CIRCUIT PLATE)


    A215917E01
  1. Disconnect the engine coolant temperature sensor connector.

  1. Disconnect the No. 3 meter circuit plate connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Tester Connection
    Condition
    Specified Condition
    G2-2 (TWS3) - L27-16 (TWS3)
    Always
    Below 1 Ω
    G2-1 (E2) - L27-9 (E2)
    Always
    Below 1 Ω

    Standard Resistance (Check for Short):
    Tester Condition
    Condition
    Specified Condition
    G2-2 (TWS3) or L27-16 (TWS3) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to No. 3 Meter Circuit Plate)
    *2
    Front view of wire harness connector
    (to Engine Coolant Temperature Sensor)

  1. Reconnect the No. 3 meter circuit plate connector.

  1. Reconnect the engine coolant temperature sensor connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - METER CIRCUIT PLATE)
OK


2.INSPECT ENGINE COOLANT TEMPERATURE SENSOR
  1. Inspect the engine coolant temperature sensor (Click here).



NG
REPLACE ENGINE COOLANT TEMPERATURE SENSOR (Click here)
OK

REPLACE NO. 3 METER CIRCUIT PLATE (Click here)