Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

INTELLIGENT PARKING ASSIST SYSTEM > Message indicating Back Door is Open is Displayed even after Back Door is Closed

for Preparation Click here


DESCRIPTION

The parking assist ECU receives back door lock assembly open/close signals from the main body ECU (multiplex network body ECU) via CAN communication. When the back door is open, the camera aiming cannot be adjusted correctly because the rear television camera assembly is installed on the back door. Therefore, when adjusting the camera aiming calibration while the back door is open, a back door open warning message will be displayed on the screen and camera aiming adjustment will be canceled.

WIRING DIAGRAM


E185965E05


INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" message is displayed on the navigation receiver assembly after the battery terminal disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (Click here).

1.READ VALUE USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Body / Main Body / Data List.

  1. Check the Data List for proper functioning of the following item.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Back Door Courtesy SW
    Back door courtesy switch signal/ON or OFF
    ON: Back door open
    OFF: Back door closed
    -

    OK:
    The back door courtesy switch functions as specified in the normal condition column.



NG
Go to step 2
OK

REPLACE PARKING ASSIST ECU (Click here)  

2.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - BACK DOOR LOCK)
  1. Disconnect the L7 connector from the main body ECU (multiplex network body ECU).

  1. Disconnect the R18 connector from the back door lock assembly.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L7-19 (BCTY) - R18-2 (+)
    Always
    Below 1 Ω
    L7-19 (BCTY) - Body ground
    Always
    10 kΩ or higher
    R18-1 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT BACK DOOR LOCK ASSEMBLY
  1. Remove the back door lock assembly (Click here).



    B228545E01
  1. Check the operation of the door lock motor.

    1. Move the door lock to the lock position.

    2. Apply battery voltage to the door lock motor and check the operation of the door lock motor.
      Connection
      Result
      Battery positive (+) → 4 (ACT+)
      Battery negative (-) → 3 (ACT-)
      Unlocks

  1. Check operation of the door courtesy switch.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Measurement Condition
      Condition
      Specified Condition
      1 (E) - 2 (+)
      Locked
      10 kΩ or higher
      1 (E) - 2 (+)
      Unlocked
      Below 1 Ω

      Text in Illustration 
      *1
      Component without harness connected
      (Back Door Lock Assembly)
      *2
      Lock
      *3
      Unlock



NG
REPLACE BACK DOOR LOCK ASSEMBLY (Click here)
OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)