BLOCKING SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.INSPECT AUXILIARY BATTERY VOLTAGE |
Measure the auxiliary battery voltage with the power switch off.
| |||||
| 3.START HYBRID CONTROL SYSTEM |
Check that the hybrid control system starts normally.
|
| ||||
| |||||
| 4.CHECK DTC OUTPUT* |
Check for DTCs and note any codes that are output (Click here).
Clear the DTCs (Click here).
| Result | Proceed to |
| DTC is not output. | A |
| Hybrid control system DTC is output. | B |
| Engine immobiliser system DTC is output. | C |
| Entry and start system (for start function) DTC is output. | D |
| Blocking system DTC is output. | E |
|
| ||||
|
| ||||
|
| ||||
|
| ||||
| |||||
| 5.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in the problem symptoms table. | A |
| Fault is listed in the problem symptoms table. | B |
|
| ||||
| |||||
| 6.OVERALL ANALYSIS AND TROUBLESHOOTING* |
Terminals of ECU (Click here)
| |||||
| 7.REPAIR OR REPLACE |
| |||||
| 8.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|