DTC P0010 Camshaft Position "A" Actuator Circuit (Bank 1) |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0010 | Open or short in camshaft timing oil control valve assembly circuit (1 trip detection logic) |
|
| Related DTCs | P0010: Camshaft timing oil control valve range check (bank 1) |
| Required Sensors/Components (Main) | Camshaft timing oil control valve assembly |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Continuous |
| Duration | 1 second |
| MIL Operation | Immediately |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| All of the following conditions are met | A, B, C and D |
| A. Starter | OFF |
| B. Power switch | On (IG) |
| C. Time after power switch off to on (IG) | 0.5 seconds or more |
| D. Either of the following condition is met | (a) or (b) |
| (a) All of the following conditions are met | 1, 2 and 3 |
| 1. Auxiliary battery voltage | 11 V or more, and less than 13 V |
| 2. Target duty cycle | Less than 70% |
| 3. Current cut status | Not cut |
| (b) All of the following conditions are met | 1, 2 and 3 |
| 1. Auxiliary battery voltage | 13 V or more |
| 2. Target duty cycle | Less than 80% |
| 3. Current cut status | Not cut |
| Camshaft position actuator oil control valve status from valve driver MIC | Fail |
| Camshaft position actuator oil control valve status from valve driver MIC | Pass |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.READ OUTPUT DTC (DTC P0010) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Clear the DTC after recording the freeze frame data and DTC.
Turn the power switch off and wait for at least 30 seconds.
Put the engine in inspection mode (maintenance mode) (Click here).
Start the engine and allow the engine to idle.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0010 is output | A |
| DTC is not output | B |
|
| ||||
| A | |
| 2.INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY |
Inspect the camshaft timing oil control valve assembly (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY - ECM) |
Disconnect the camshaft timing oil control valve assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| D25-1 (+) - D28-36 (OC1+) | Always | Below 1 Ω |
| D25-2 (-) - D28-59 (OC1-) | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| D25-1 (+) or D28-36 (OC1+) - Body ground | Always | 10 kΩ or higher |
| D25-2 (-) or D28-59 (OC1-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||