DTC P0125 Insufficient Coolant Temperature for Closed Loop Fuel Control |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0125 | Engine coolant temperature does not reach closed-loop enabling temperature for 20 minutes (this period varies with engine start engine coolant temperature) (2 trip detection logic) |
|
| Related DTCs | P0125: Insufficient engine coolant temperature for closed-loop fuel control |
| Required Sensors/Components (Main) | Engine coolant temperature sensor Water inlet with thermostat sub-assembly Cooling system |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 85 seconds: Engine coolant temperature at engine start -3.33°C (26°F) or more 164 seconds: Engine coolant temperature at engine start -14.44 (6°F) or more, and less than -3.33°C (26°F) 1200 seconds: Engine coolant temperature at engine start less than -14.44°C (6°F) |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | None |
| All of the following conditions are met | - |
| Thermostat fail (P0128) | Not detected |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118) | Not detected |
| Mass air flow meter circuit fail (P0102, P0103) | Not detected |
| Time until actual engine coolant temperature reaches closed-loop fuel control enabling temperature | 85 seconds: Engine coolant temperature at engine start -3.33°C (26°F) or more 164 seconds: Engine coolant temperature at engine start -14.44 (6°F) or more, and less than -3.33°C (26°F) 1200 seconds: Engine coolant temperature at engine start less than -14.44°C (6°F) |
| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0125) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0125 is output | A |
| DTC P0125 and other DTCs are output | B |
|
| ||||
| A | |
| 2.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY |
Remove the water inlet with thermostat sub-assembly (Click here).
Check the valve opening temperature of the water inlet with thermostat sub-assembly.
|
| ||||
| OK | |
| 3.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal radiator fan operation or any modifications.
|
| ||||
| OK | ||
| ||