SEAT POSITION SENSOR > INSTALLATION |
| 1. INSTALL SEAT POSITION SENSOR (for Manual Seat) |
![]() |
Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.
![]() |
Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor with the "TORX" screw.
| *1 | Seat Position Sensor |
| *2 | Feeler Gauge |
| *3 | Seat Rail |
![]() |
Using a T30 "TORX" socket wrench, tighten the "TORX" screw.
Make sure that the clearance between the seat position sensor and seat rail is 1.3 mm (0.0512 in.).
Install the wire harness to the seat slide position sensor protector.
Connect the connector.
Check that there is no looseness in the installation parts of the seat position sensor.
| 2. INSTALL SEAT POSITION SENSOR (for Power Seat) |
![]() |
Install the seat position sensor to the seat slide position sensor protector with the pin as shown in the illustration.
![]() |
Using a 1.3 mm (0.0512 in.) feeler gauge, temporarily install the seat position sensor with the "TORX" screw and nut.
| *1 | Seat Position Sensor |
| *2 | Feeler Gauge |
| *3 | Seat Rail |
![]() |
Using a T30 "TORX" socket wrench, tighten the "TORX" screw and nut.
Make sure that the clearance between the seat position sensor and seat rail is 1.3 mm (0.0512 in.).
![]() |
Install the wire harness to the 2 hooks.
Connect the connector.
Check that there is no looseness in the installation parts of the seat position sensor.
| 3. INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY LH (for Manual Seat) |
![]() |
Engage the clip and 6 claws to install the front seat cushion shield.
Install the screw.
| 4. INSTALL VERTICAL ADJUSTING HANDLE LH (for Manual Seat) |
![]() |
Install the vertical adjusting handle with the screw.
| 5. INSTALL RECLINING ADJUSTER RELEASE HANDLE LH (for Manual Seat) |
![]() |
Engage the claw and install the reclining adjuster release handle.
| 6. INSTALL FRONT SEAT ASSEMBLY LH |