Home › Vehicle Interior › SEAT › FRONT SEAT ASSEMBLY (for Manual Seat)

FRONT SEAT ASSEMBLY (for Manual Seat) > INSTALLATION

for Preparation Click here



1. INSTALL FRONT SEAT ASSEMBLY
  1. Place the front seat assembly in the cabin.

    NOTICE:
    Be careful not to damage the vehicle body.

  1. Connect each connector and clamp under the seat.

  1. Temporarily install the front seat assembly with the 4 bolts.

  1. Lift up the seat track adjusting handle and move the seat to the rearmost position.



    B229808E01
  1. Tighten the 2 bolts on the front side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.

  1. Lift up the seat track adjusting handle and move the seat to the foremost position.



    B229807E01
  1. Tighten the 2 bolts on the rear side of the seat.

    Torque:
    37 N*m{ 377 kgf*cm , 27 ft.*lbf }

    HINT:
    Tighten the bolts in the order indicated in the illustration.



2. ZERO POINT CALIBRATION AND SENSITIVITY CHECK (for Front Passenger Seat)
(Click here)


3. INSTALL INNER SEAT TRACK COVER


    B229803
  1. Engage the guide and claw to install the inner seat track cover.



4. INSTALL OUTER SEAT TRACK COVER


    B229805
  1. Engage the 2 claws to install the outer seat track cover.



5. INSTALL FRONT SEAT HEADREST ASSEMBLY


6. CONNECT CABLE TO AUXILIARY BATTERY NEGATIVE TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



7. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



8. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



9. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



10. INSPECT FRONT SEAT ASSEMBLY
  1. During sliding operation of the front seat, check that the left and right adjusters move together smoothly and lock simultaneously.
    If the seat adjusters do not lock simultaneously, loosen the seat mounting bolts to adjust the adjuster position.

  1. w/ Seat Heater Seat System:
    Check the seat heater operation.

    1. Turn the power switch to on (IG).

    2. Push the seat heater switch on.

    3. Wait 5 minutes or more and confirm that the seat surface becomes warm.



11. INSPECT SRS WARNING LIGHT
(Click here)