CAN COMMUNICATION SYSTEM > ECM Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| ECM Communication Stop Mode |
|
|

| 1.CHECK CAN BUS WIRE FOR DISCONNECTION (ECM MAIN WIRE) |
Turn the power switch off.
![]() |
Disconnect the ECM connector.
| *1 | Front view of wire harness connector (to ECM) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A57-13 (CANH) - A57-5 (CANL) | Power switch off | 108 to 132 Ω |
|
| ||||
| OK | |
| 2.CHECK ECM POWER SOURCE CIRCUIT |
Check the ECM power source circuit (Click here).
|
| ||||
| OK | ||
| ||