Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Start Function)

SMART KEY SYSTEM (for Start Function) > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.


Smart Key System 
Symptom
Suspected Area
See page
Power Source Mode does not Change to ON (IG and ACC)
Indoor electrical key oscillator*1
Click here
Smart key system (for Entry function)
Click here
AM2 fuse
-
Power management control ECU
-
Power switch
-
Wire harness or connector
-
Power Source Mode does not Change to ON (IG)
Indoor electrical key oscillator*1
Click here
AM2 fuse
Click here
IG1 relay
-
IG2 relay
-
Instrument panel junction block assembly
-
Engine room relay block
-
Power management control ECU
-
Wire harness or connector
-
Power Source Mode does not Change to ON (ACC)
Indoor electrical key oscillator*1
Click here
AM2 fuse
Click here
ACC relay
-
Instrument panel junction block assembly
-
Power management control ECU
-
Wire harness or connector
-
Power Source Mode does not Change to ON (Ready)
Indoor electrical key oscillator*1
Click here
Smart key system (for Entry function)
Click here
Stop light switch
-
Engine room relay block
-
Engine immobiliser system
-
Hybrid control system
-
Transmission control ECU assembly
-
Power management control ECU
-
Wire harness or connector
-
  1. *1: w/o Entry Function