Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > Tire Pressure Warning Reset Switch Circuit

for Preparation Click here


DESCRIPTION

Initialization can be started by pressing the tire pressure warning reset switch and holding it for 3 seconds or more. If the ECU receives the signal from the switch, the tire pressure warning light blinks 3 times (1 second on, 1 second off).

WIRING DIAGRAM


C148712E13


INSPECTION PROCEDURE

NOTICE:
  1. When replacing the tire pressure warning ECU, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  2. It is necessary to perform initialization (Click here) after registration (Click here) of the transmitter IDs into the tire pressure warning ECU, after the ECU has been replaced.

1.CHECK TIRE PRESSURE WARNING RESET SWITCH FUNCTION
  1. Perform the tire pressure warning reset switch test in Test Mode Procedure (Click here).

    OK:
    Reset switch ON:
    Tire pressure warning light comes on.
    Reset switch OFF:
    Tire pressure warning light blinks.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.INSPECT TIRE PRESSURE WARNING RESET SWITCH


    C212185E01
  1. Disconnect the tire pressure warning reset switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    1 (INT) - 2 (E)
    ON
    Below 1 Ω
    OFF
    10 kΩ or higher



NG
REPLACE TIRE PRESSURE WARNING RESET SWITCH (Click here)
OK


3.CHECK HARNESS AND CONNECTOR (TIRE PRESSURE WARNING RESET SW - TIRE PRESSURE WARNING ECU)
  1. Disconnect the tire pressure warning reset switch L25 connector and tire pressure warning ECU L4 connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    L4-1 (CLSW) - L25-1 (INT)
    Always
    Below 1 Ω
    L4-1 (CLSW) - Body ground
    10 kΩ or higher
    L25-2 (E) - Body ground
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE TIRE PRESSURE WARNING ECU (Click here)