DTC B1471/71 A/C Inverter High Voltage Power Resource System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B1471/71 |
|
|

| 1.CHECK CAN COMMUNICATION SYSTEM |
Using the Techstream to check if the CAN communication system is functioning normally.
| Result | Proceed to |
| CAN DTC is not output | A |
| CAN DTC is output | B |
|
| ||||
| A | |
| 2.CHECK DIAGNOSTIC TROUBLE CODE (HYBRID CONTROL SYSTEM) |
Check if DTCs for the hybrid control system are output using the Techstream.
|
| ||||
| OK | |
| 3.INSPECT ELECTRIC VEHICLE FUSE |
Turn the power switch off.
Remove the service plug grip.
Remove the inverter terminal cover.
![]() |
Check that bolts A and B are tightened securely.
Measure the resistance according to the value(s) in the table below.
| Tester Item (Tester Connection) | Condition | Specified Condition |
| ELECTRIC VEHICLE fuse (A - B) | Always | Below 1 Ω |
| *1 | Inverter with Converter Assembly |
| *2 | Electric Vehicle Fuse |
|
| ||||
| OK | |
| 4.INSPECT NO. 2 ENGINE WIRE |
![]() |
Disconnect the No. 2 engine wire connector.
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| E1-1 (PE) - E3-2 (ACPE) | Always | Below 1 Ω |
| E1-2 (PB) - E3-1 (ACPB) | Always | Below 1 Ω |
| E1-1 (PE) - Body ground | Always | 10 kΩ or higher |
| E1-2 (PB) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Compressor with Motor Assembly) |
| *2 | Front view of wire harness connector (to Inverter with Converter Assembly) |
|
| ||||
| OK | ||
| ||