Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Start Function)

DTC    B2286    Runnable Signal Malfunction

for Preparation Click here


DESCRIPTION

This DTC is stored when a malfunction is detected in the READY signal circuit inside the power management control ECU.

DTC No.
DTC Detection Condition
Trouble Area
B2286
READY signal error inside the power management control ECU.
  1. AM2 fuse
  2. Power management control ECU
  3. Wire harness or connector

WIRING DIAGRAM


B337140E01


INSPECTION PROCEDURE

NOTICE:
  1. When the power management control ECU is replaced with a new one and the cable from the negative (-) auxiliary battery terminal is connected, the power source mode becomes on (IG) mode. When the auxiliary battery is removed and reinstalled, the power source mode that was selected when the auxiliary battery was removed is restored.
  2. Inspect the fuses for circuits related to this system before performing the following inspection procedure.

HINT:
Check the connector connection to the terminal to make sure that there is no abnormality such as a loose connection, deformation, etc.

1.CHECK HARNESS AND CONNECTOR (AUXILIARY BATTERY - POWER MANAGEMENT CONTROL ECU)
  1. Disconnect the L5 and L6 connectors from the power management control ECU.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L5-1 (AM22) - Body ground
    Always
    9.5 to 16 V
    L6-7 (AM21) - Body ground
    Always
    9.5 to 16 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (AUXILIARY BATTERY - POWER MANAGEMENT CONTROL ECU)
OK


2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND)
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    L5-5 (E01) - Body ground
    Always
    Below 1 Ω
    L5-6 (E1) - Body ground
    Always
    Below 1 Ω
    L6-4 (E12) - Body ground
    Always
    Below 1 Ω
    L6-5 (E02) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (POWER MANAGEMENT CONTROL ECU - BODY GROUND)
OK


3.CHECK FOR DTC
  1. Clear the DTC (Click here).

  1. Turn the power switch on (READY).

  1. After 25 seconds have elapsed, check if the DTC has been set again.

    OK:
    DTC B2286 is not output



NG
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
OK

USE SIMULATION METHOD TO CHECK (Click here)