ELECTRONICALLY CONTROLLED BRAKE SYSTEM > Slip Indicator Light does not Come ON |
| 1.CHECK CAN COMMUNICATION SYSTEM |
Check if a CAN communication system DTC is output (Click here).
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.PERFORM ACTIVE TEST USING TECHSTREAM (SLIP INDICATOR LIGHT) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Select the Active Test on the Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Slip Indicator Light | Slip indicator light | Indicator light ON/OFF | Observe combination meter |
Check that the slip indicator light on the combination meter turns on or off in accordance with the Techstream operation.
|
| ||||
| OK | ||
| ||
| 3.INSPECT COMBINATION METER |
Turn the power switch off.
Perform the Active Test of the combination meter (meter CPU) using the Techstream (Click here).
Check the combination meter.
|
| ||||
| OK | ||
| ||
| 4.REPLACE NO. 5 METER CIRCUIT PLATE |
Replace the No. 5 meter circuit plate (Click here).
Perform the Active Test of the combination meter (meter CPU) using the Techstream (Click here).
Check the combination meter.
|
| ||||
| OK | ||
| ||
| 5.REPLACE NO. 2 METER CIRCUIT PLATE |
Replace the No. 2 meter circuit plate (Click here).
Perform the Active Test of the combination meter (meter CPU) using the Techstream (Click here).
Check the combination meter.
|
| ||||
| OK | ||
| ||