DTC C1391/69 Accumulator Leak Malfunction |
| DTC Code | INF Code | DTC Detection Condition | Trouble Area |
| C1391/69 | 351 | Either of the following is detected:
|
|
| 1.CHECK FOR FLUID LEAK |
Check that there is no fluid leaks in the brake line between the brake actuator and the wheel cylinder which is indicated by DTCs.
Check that the brake is not dragging.
|
| ||||
| OK | |
| 2.RECONFIRM DTC |
Clear the DTCs (Click here).
Turn the power switch on (READY).
Check if the same DTC is recorded (Click here).
| Result | Proceed to |
| DTC (C1391/69) is output | A |
| DTC (C1391/69) is not output | B |
|
| ||||
| A | |
| 3.PERFORM ACTIVE TEST USING TECHSTREAM (SOLENOID VALVE) |
Turn the power switch off.
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Select the Active Test on the Techstream (Click here).
| Tester Display | Test Part | Control Range | Diagnostic Note |
| ECB* Solenoid (SMC/SRC/SCC) | Switching solenoid valve (SMC/SRC/SCC) | Solenoid ON/OFF | Operation sound of solenoid (clicking sound) can be heard |
Perform the Active Test of the solenoid using the Techstream.
Select the Data List on the Techstream (Click here).
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Wheel Cylinder Pressure Sensor | Wheel cylinder pressure sensor / Min.: 0 V, Max.: 5 V | When brake pedal released: 0.1 to 0.9 V | Reading increases when brake pedal is depressed |
Check that the output value of wheel cylinder does not increase.
| Result | Proceed to |
| The output value of wheel cylinder increases | A |
| The output values of wheel cylinders do not increase | B |
|
| ||||
| A | |
| 4.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER |
Replace the brake booster with master cylinder (brake actuator) (Click here).
| NEXT | ||
| ||