DTC P1578 Brake System Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| P1578 | The power management control ECU receives a brake system error signal for 0.2 sec. or more while the cruise control is in operation | Electronically controlled brake system |

| 1.CHECK DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
Read the DTC.
| Result | Proceed to |
| DTC is not output | A |
| DTC is output | B |
|
| ||||
| A | |
| 2.CHECK WHETHER DTC OUTPUT RECORDS (CRUISE CONTROL SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch (ON-OFF button) on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P1578 is output | B |
|
| ||||
| A | ||
| ||
| 3.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER |
| NEXT | |
| 4.CHECK WHETHER DTC OUTPUT RECORDS (CRUISE CONTROL SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Clear the DTC (Click here).
Perform the following to make sure that the DTC detection conditions are met.
Drive the vehicle at a speed for which cruise control operation is possible.
Turn the cruise control main switch (ON-OFF button) on.
Push the -SET switch to activate the cruise control.
Enter the following menus: Powertrain / Cruise Control / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC is not output | A |
| DTC P1578 is output | B |
|
| ||||
| A | ||
| ||