Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL OCCUPANT CLASSIFICATION ECU


    B228034
  1. Install the occupant classification ECU with the claw.

    NOTICE:
    If the occupant classification ECU has been dropped, or there are any cracks, dents or other defects in the case or connector, replace the occupant classification ECU with a new one.

  1. Connect the 2 connectors.

    NOTICE:
    When installing the occupant classification ECU, be careful that the SRS wiring does not interfere with or is pinched between other parts.



2. INSTALL FRONT SEAT CUSHION COVER RH


    B299253
  1. Install the front seat cushion cover RH to the occupant classification ECU as shown in the illustration.



    B299251
  1. Install the clip.



3. INSTALL FRONT SEAT ASSEMBLY RH

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. Refer to the procedure from Install Front Seat Assembly (Click here).



4. ZERO POINT CALIBRATION AND SENSITIVITY CHECK
  1. Perform zero point calibration and sensitivity check (Click here).



5. PERFORM DIAGNOSTIC SYSTEM CHECK
  1. Perform a diagnostic system check (Click here).



6. INSPECT SRS WARNING LIGHT
  1. Inspect the SRS warning light (Click here).