Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › OCCUPANT CLASSIFICATION ECU

OCCUPANT CLASSIFICATION ECU > REMOVAL

for Preparation Click here



1. PRECAUTION

CAUTION:
Be sure to read Precaution thoroughly before servicing (Click here).

NOTICE:
  1. When removing front seat assembly RH, perform zero point calibration and sensitivity check (Click here).
  2. When replacing the occupant classification ECU, perform zero point calibration and sensitivity check (Click here).



2. REMOVE FRONT SEAT ASSEMBLY RH

HINT:
  1. Use the same procedure for the RH side and LH side.
  2. Refer to the procedure up to Remove Front Seat Assembly (Click here).



3. REMOVE FRONT SEAT CUSHION COVER RH


    B299251
  1. Using a clip remover, remove the clip.



    B299252
  1. Remove the front seat cushion cover RH from the occupant classification ECU as shown in the illustration.



4. REMOVE OCCUPANT CLASSIFICATION ECU


    B228033E01
  1. Disconnect the 2 connectors.

  1. Using a screwdriver with the tip wrapped with protective tape, disengage the claw and remove the occupant classification ECU.
    Text in Illustration 
    *1
    Protective Tape