DTC B15FE XM Tuner Antenna Disconnected |
DTC B15FF XM Tuner Antenna Short |
| DTC No. | DTC Detection Condition | Trouble Area |
| B15FE | The amplifier antenna assembly is not connected. |
|
| B15FF | A short occurs in the amplifier antenna assembly. |
| 1.REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Replace the No. 2 antenna cord sub-assembly (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 2.INSPECT NO. 4 ANTENNA CORD SUB-ASSEMBLY |
Disconnect the No. 4 antenna cord sub-assembly.
Measure the resistance of the No. 4 antenna cord sub-assembly to check for an open circuit in the No. 4 antenna cord sub-assembly.
Measure the resistance between the No. 4 antenna cord sub-assembly and body ground to check for a short circuit in the No. 4 antenna cord sub-assembly.
|
| ||||
| OK | |
| 3.INSPECT NO. 5 ANTENNA CORD SUB-ASSEMBLY |
Disconnect the No. 5 antenna cord sub-assembly.
Measure the resistance of the No. 5 antenna cord sub-assembly to check for an open circuit in the No. 5 antenna cord sub-assembly.
Measure the resistance between the No. 5 antenna cord sub-assembly and body ground to check for a short circuit in the No. 5 antenna cord sub-assembly.
|
| ||||
| OK | |
| 4.REPLACE ROOF ANTENNA POLE SUB-ASSEMBLY |
Replace the roof antenna pole sub-assembly (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 5.REPLACE AMPLIFIER ANTENNA ASSEMBLY (for Roof) |
Replace the amplifier antenna assembly (for Roof) (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||