Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brushless Type Motor)

POWER STEERING SYSTEM (for Brushless Type Motor) > EPS Warning Light Circuit

for Preparation Click here


DESCRIPTION

If the power steering ECU assembly detects a malfunction, the P/S warning light comes on. At this time, the power steering ECU assembly stores a DTC in its memory.

WIRING DIAGRAM


C210565E17


INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    DTC is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (POWER STEERING ECU ASSEMBLY - BODY GROUND)
  1. Disconnect the connectors from the power steering ECU assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L54-6 (IG) - A27-2 (PGND)
    Power switch on (IG)
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    A27-2 (PGND) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Turn the power switch off.

  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Combination Meter / Active Test.

  1. Perform the Active Test of the combination meter using the Techstream.


Combination Meter 
Tester Display
Test Part
Control Range
Diagnostic Note
Indicat. EPS
EPS warning light
OFF or ON
Confirm that the vehicle is stopped with the engine idling
  1. Check that the EPS warning light operates in accordance with the Active Test.

    HINT:
    Reconnect the connectors and restore the vehicle to its previous condition before checking the combination meter.



NG
REPLACE METER CIRCUIT PLATE NO.3 (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)