Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brush Type Motor)

DTC    C1581    Assist Map Number Un-Writing

for Preparation Click here


DESCRIPTION

DTC C1581 will be stored if the power steering ECU determines that the assist map is not written in the ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1581
Assist map is not written in power steering ECU
  1. Power steering ECU
  2. Hybrid control system
  3. CAN communication system

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU has been replaced with a new one, perform the assist map writing and the torque sensor zero point calibration (Click here).

1.PERFORM ASSIST MAP WRITING
  1. Perform the assist map writing (Click here).


NEXT


2.CHECK FOR DTC
  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC is still output even after performing assist map writing 3 times.
    A
    DTC is still output even after performing assist map writing once or twice*1
    B
    DTC is not output.
    C

    HINT:
    *1: Perform the assist map writing again if DTC C1581 is still output even after the assist map writing is performed once or twice.



B
PERFORM ASSIST MAP WRITING AGAIN (Click here)

C
END
A


3.CHECK FOR DTC (CAN COMMUNICATION SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    DTC is not output.

    HINT:
    If the CAN communication system DTC is output, first troubleshoot the CAN communication system malfunction, then perform the assist map writing again (Click here).



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK


4.CHECK FOR DTC (HYBRID CONTROL SYSTEM)
  1. Check for DTCs (Click here).

    OK:
    DTC is not output.

    HINT:
    If the hybrid control system DTC is output, first troubleshoot the hybrid control system, then perform the assist map writing again (Click here).



NG
REPAIR CIRCUITS INDICATED BY OUTPUT DTCS (Click here)
OK

REPLACE POWER STEERING ECU (Click here)