Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM (for Brushless Type Motor)

DTC    C1541    Vehicle Speed Signal Malfunction

for Preparation Click here


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the skid control ECU via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed, based on the signals.
If the ECU detects this DTC, it adjusts the amount of power assistance for a speed of 100 km/h (62 mph) and continues the system control.

DTC No.
DTC Detection Condition
Trouble Area
C1541
This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more.
  1. Speed sensor circuit
  2. Brake booster with master cylinder (skid control ECU)
  3. CAN communication system
  4. Power steering ECU assembly

INSPECTION PROCEDURE

NOTICE:
If the power steering ECU assembly has been replaced, perform rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Check if DTC U0129 is output.

    Result:
    Result
    Proceed to
    No output
    A
    U0129 is output
    B

    HINT:
    DTC U0129 indicates a skid control ECU communication malfunction in the power steering system.



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK OTHER DTC OUTPUT (BRAKE CONTROL SYSTEM)
  1. Check for DTCs of the brake control system (Click here).

    OK:
    DTC of speed sensor malfunction is not output.

    NOTICE:
    If replacing the power steering ECU assembly, initialize rotation angle sensor and calibrate torque sensor zero point (Click here).



NG
REPAIR CIRCUIT INDICATED BY OUTPUT CODE (Click here)
OK

REPLACE POWER STEERING ECU ASSEMBLY (Click here)