DTC B2341 Sensor (Motor) Failure |
DTC B2344 Position Failure |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2341 | Sensor (motor) failure (When the ECU enters fail-safe mode due to a problem with the motor) |
|
| B2344 | Position failure (When the ECU enters fail-safe mode due to a problem with the gear position) |
|

| 1.CHECK SLIDING ROOF OPERATION |
Check the sliding roof auto operation (Click here).
|
| ||||
| OK | |
| 2.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 3.INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) |
Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized (Click here).
|
| ||||
| OK | |
| 4.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||
| 5.CHECK HARNESS AND CONNECTOR (SLIDING ROOF ECU - SLIDING ROOF SWITCH) |
![]() |
Disconnect the sliding roof switch (map light assembly) connector.
Disconnect the sliding roof ECU (sliding roof drive gear sub-assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| R23-9 (CLS) - U13-2 (CLS) | Always | Below 1 Ω |
| R23-9 (CLS) - Body ground | Always | 10 kΩ or higher |
| R23-7 (OPN) - U13-16 (OPN) | Always | Below 1 Ω |
| R23-7 (OPN) - Body ground | Always | 10 kΩ or higher |
| U13-9 (GND1) - Body ground | Always | Below 1 Ω |
| R23-2 (E) - Body ground | Always | Below 1 Ω |
| *1 | Front view of wire harness connector (to Sliding Roof ECU (Sliding Roof Drive Gear Sub-assembly)) |
| *2 | Front view of wire harness connector (to Sliding Roof Switch (Map Light Assembly)) |
|
| ||||
| OK | |
| 6.INSPECT SLIDING ROOF SWITCH (MAP LIGHT ASSEMBLY) |
![]() |
Remove the sliding roof switch (map light assembly) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| U13-2 (CLS) - U13-9 (GND1) | CLOSE switch is pressed | Below 1 Ω |
| U13-2 (CLS) - U13-9 (GND1) | CLOSE switch is not pressed | 10 kΩ or higher |
| U13-16 (OPN) - U13-9 (GND1) | OPEN switch is pressed | Below 1 Ω |
| U13-16 (OPN) - U13-9 (GND1) | OPEN switch is not pressed | 10 kΩ or higher |
| *1 | Component without harness connected (Sliding Roof Switch (Map Light Assembly)) |
|
| ||||
| OK | ||
| ||