DTC U0129 Lost Communication with Brake System Control Module |
| DTC No. | DTC Detection Condition | Trouble Area |
| U0129 | No communication from the skid control ECU continues. |
|

| 1.RECONFIRM DTC OUTPUT |
Reconfirm DTCs.
| Result | Proceed to |
| U1002 is not output from power management control ECU (Techstream display/Power Management2) | A |
| U1002 is output from power management control ECU (Techstream display/Power Management2) | B |
|
| ||||
| A | |
| 2.CHECK DTC (BRAKE SYSTEM) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Chassis / ABS/VSC/TRAC / Trouble Codes.
|
| ||||
| OK | |
| 3.CHECK CAN BUS WIRE FOR DISCONNECTION (SKID CONTROL ECU) |
Turn the power switch off.
![]() |
Disconnect the skid control ECU connector.
| *1 | Front view of wire harness connector (to Skid Control ECU) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| A58-35 (CA2H) - A58-34 (CA2L) | Power switch off | 54 to 69 Ω |
|
| ||||
| OK | ||
| ||