Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A02    Vehicle Information Not Obtained

for Preparation Click here


DESCRIPTION

When the driving support ECU is replaced with a new one, it acquires the country specification information (destination, steering wheel position, etc.) from the main body ECU. When the country specification information in the driving support ECU and main body ECU do not match, DTC C1A02 is stored.

DTC No.
DTC Detection Condition
Trouble Area
C1A02
Inconsistent vehicle specification information between the main body ECU and driving support ECU continues for 1 second or more
  1. Driving support ECU
  2. Main body ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch on (IG).

  1. Recheck for DTCs (Click here).

    OK:
    DTC C1A02 is not output.



NG
GO TO CAN COMMUNICATION SYSTEM (Click here)
OK

REPLACE DRIVING SUPPORT ECU (Click here)