Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A0C    Object Recognition Camera Region Code Mismatch

for Preparation Click here


DESCRIPTION

When the lane recognition camera sensor assembly is replaced with a new one, it acquires the country specification information from the driving support ECU. The lane recognition camera sensor assembly has information about the market it is intended for use in (country specification information such as the destination, steering wheel position etc.). When a new camera sensor is installed and the country specification information does not match that of the driving support ECU, the ECU stores DTC C1A0C.

DTC No.
DTC Detection Condition
Trouble Area
C1A0C
While initial check is running, power switch is on (IG) and system is operating, country specification information in driving support ECU and lane recognition camera sensor assembly do not match
  1. Lane recognition camera sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE

NOTICE:
When the lane recognition camera sensor assembly is replaced with a new one, adjust the lane recognition camera sensor assembly (Click here).

1.REPLACE LANE RECOGNITION CAMERA SENSOR ASSEMBLY
  1. Replace lane recognition camera sensor assembly (Click here).

  1. Adjust the lane recognition camera sensor assembly (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC C1A0C is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END