Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM

DTC    C1A0C    Object Recognition Camera Region Code Mismatch

for Preparation Click here


DESCRIPTION

w/ Lane-keeping Assist System
When the lane recognition camera sensor assembly is replaced with a new one, it acquires the country specification information from the driving support ECU. The lane recognition camera sensor assembly has information about the market it is intended for use in (country specification information such as the destination, steering wheel position etc.). When a new camera sensor is installed and the country specification information does not match that of the driving support ECU, the ECU stores DTC C1A0C.

DTC No.
DTC Detection Condition
Trouble Area
C1A0C
While initial check is running, power switch is on (IG) and system is operating, country specification information in driving support ECU and lane recognition camera sensor assembly do not match
  1. Lane recognition camera sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE

NOTICE:
When the lane recognition camera sensor assembly is replaced with a new one, adjust the lane recognition camera sensor assembly (Click here).

1.REPLACE LANE RECOGNITION CAMERA SENSOR ASSEMBLY
  1. Replace lane recognition camera sensor assembly (Click here).

  1. Adjust the lane recognition camera sensor assembly (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed of 40 km/h (25 mph) or more.

    2. Turn the cruise control main switch on.

    3. Push the -SET switch to activate the cruise control.

  1. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE DRIVING SUPPORT ECU (Click here)
A

USE SIMULATION METHOD TO CHECK (Click here)