Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM

DTC    C1A20    Object Recognition ECU

for Preparation Click here


DESCRIPTION

w/ Lane-keeping Assist System
When the driving support ECU receives information that there is a malfunction in the lane recognition camera sensor assembly, DTC C1A20 is output.

DTC No.
DTC Detection Condition
Trouble Area
C1A20
While power switch is on (IG), driving support ECU receives information that there is malfunction in lane recognition camera sensor assembly for 1 second or more
  1. Lane recognition camera sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE

NOTICE:
When the lane recognition camera sensor assembly is replaced with a new one, adjust the lane recognition camera sensor assembly (Click here).

1.REPLACE LANE RECOGNITION CAMERA SENSOR ASSEMBLY
  1. Replace the lane recognition camera sensor assembly (Click here).

  1. Adjust the lane recognition camera sensor assembly (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Clear the DTCs (Click here).

  1. Perform the following to make sure that the DTC detection conditions are met.

    HINT:
    If the detection conditions are not met, the malfunction cannot be detected.

    1. Drive the vehicle at a speed for which cruise control operation is possible.

    2. Turn the cruise control main switch on.

    3. Push the -SET switch to activate the cruise control.

  1. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
REPLACE DRIVING SUPPORT ECU (Click here)
A

END