Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A46    Yaw Rate Sensor

for Preparation Click here


DESCRIPTION

The brake booster with master cylinder (skid control ECU) receives vehicle stability signals from the yaw rate sensor and sends the signals to the driving support ECU. If the brake booster with master cylinder (skid control ECU) detects that the yaw rate sensor is malfunctioning, the brake booster with master cylinder (skid control ECU) sends a malfunction signal to the driving support ECU and outputs DTC C1A46. Also, when DTC C1A46 is stored, the brake booster with master cylinder (skid control ECU) stores DTC at the same time.

DTC No.
DTC Detection Condition
Trouble Area
C1A46
While vehicle speed is 50 km/h (31 mph) or more, malfunction signal from brake booster with master cylinder (skid control ECU), yaw rate sensor to driving support ECU is detected for 1 second or more
  1. Yaw rate sensor
  2. Brake booster with master cylinder (skid control ECU)
  3. Driving support ECU

INSPECTION PROCEDURE

1.CHECK FOR DTC (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
  1. Check for DTCs (electronically controlled brake system) (Click here).

    OK:
    Electronically controlled brake system DTC is not output.



NG
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (Click here)
OK


2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
  1. Replace the brake booster with master cylinder (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC C1A46 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END