Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A4A    Skid Control Buzzer Circuit

for Preparation Click here


DESCRIPTION

If the vehicle is about to move out of the lane markers while the lane-keeping assist function is operating, the driving support ECU sends a sounding signal to the brake booster with master cylinder (skid control ECU) to sound the skid control buzzer in order to warn the driver.

DTC No.
DTC Detection Condition
Trouble Area
C1A4A
While power switch is on (IG), skid control buzzer circuit malfunction signal is received by brake booster with master cylinder (skid control ECU) for 1 second or more
  1. Skid control buzzer
  2. Skid control buzzer circuit
  3. Brake booster with master cylinder (skid control ECU)
  4. Driving support ECU

INSPECTION PROCEDURE

1.PERFORM ACTIVE TEST USING TECHSTREAM (SKID CONTROL BUZZER)
  1. Using the Techstream, enter the following menus: Chassis / ABS/VSC/TRAC / Active Test / Buzzer.

  1. Perform Active Test.

    ABS/VSC/TRAC 
    Tester Display
    Test Part
    Control Range
    Diagnosis Note
    Buzzer
    Skid control buzzer sounds
    ON / OFF
    -

    OK:
    Skid control buzzer sounds.



NG
GO TO ELECTRONICALLY CONTROLLED BRAKE SYSTEM (Click here)
OK


2.REPLACE BRAKE BOOSTER WITH MASTER CYLINDER
  1. Replace the brake booster with master cylinder (skid control ECU) (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Recheck for DTCs.

    OK:
    DTC C1A4A is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END