Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A70    Power Steering Control System

for Preparation Click here


DESCRIPTION

When the lane departure warning function operates, the driving support ECU sends a signal to the power steering control ECU to operate the steering motor.

DTC No.
DTC Detection Condition
Trouble Area
C1A70
When vehicle speed is 50 km/h (31 mph) or more with lane-keeping assist switch on, malfunction signal of power steering system is input to driving support ECU
  1. Power steering system
  2. CAN communication system
  3. Driving support ECU

INSPECTION PROCEDURE

1.CHECK FOR DTC (POWER STEERING SYSTEM)
  1. Check for DTCs (power steering system) (Click here).

    OK:
    Power steering system DTC is not output.

    HINT:
    If DTC C1A70 is output even after troubleshooting the power steering system, replace the driving support ECU.



NG
GO TO POWER STEERING SYSTEM (Click here)
OK


2.REPLACE POWER STEERING CONTROL ECU
  1. Replace the power steering control ECU (Click here).


NEXT


3.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC C1A70 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END