Home › Engine / Hybrid System › CRUISE CONTROL › LANE-KEEPING ASSIST SYSTEM

DTC    C1A22    Object Recognition Camera Incorrect Axial Gap

DTC    C1A23    Object Recognition Camera Initialization Incomplete

for Preparation Click here


DESCRIPTION

If the driving support ECU determines that the lane recognition camera sensor assembly axis is deviated, DTC C1A22 is output. Also, if the lane recognition camera sensor assembly beam axis adjustment is not performed after installing the lane recognition camera sensor assembly, DTC C1A23 is stored.

DTC No.
DTC Detection Condition
Trouble Area
C1A22
When vehicle speed is 50 km/h (31 mph) or more with lane-keeping main switch is on, driving support ECU detects lane recognition camera sensor assembly beam axis deviation for 1 second or more
  1. Lane recognition camera sensor assembly
  2. Driving support ECU
C1A23
When vehicle speed is 50 km/h (31 mph) or more with lane-keeping main switch is on, driving support ECU detects that lane recognition camera sensor assembly adjustment has not been completed for 1 second or more
  1. Lane recognition camera sensor assembly
  2. Driving support ECU

INSPECTION PROCEDURE

NOTICE:
When the lane recognition camera sensor assembly is replaced with a new one, adjust the lane recognition camera sensor assembly (Click here).

1.ADJUST LANE RECOGNITION CAMERA SENSOR ASSEMBLY
  1. Adjust the lane recognition camera sensor assembly (Click here).


NEXT


2.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC is not output.



NG
Go to step 3
OK

END 

3.REPLACE LANE RECOGNITION CAMERA SENSOR ASSEMBLY
  1. Replace the lane recognition camera sensor assembly (Click here).

  1. Adjust the lane recognition camera sensor assembly (Click here).


NEXT


4.CHECK DTC OUTPUT
  1. Using the Techstream, enter the following menus: All ECUs / Lane Keeping Assist / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Drive the vehicle at a speed of 50 km/h (31 mph) or more, and operate lane keeping assist control.

  1. Recheck for DTCs.

    OK:
    DTC is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

END