Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › SMART KEY SYSTEM (for Entry Function)

SMART KEY SYSTEM (for Entry Function) > Entry Answer-back Buzzer does not Sound

for Preparation Click here


DESCRIPTION

The smart key system uses the wireless door lock buzzer assembly to perform various vehicle exterior warnings. When the conditions for each warning are met, the certification ECU (smart key ECU assembly) sends a buzzer request signal to the main body ECU (multiplex network body ECU) via CAN communication. The wireless door lock assembly sounds the buzzer according to the signal from the main body ECU (multiplex network body ECU).

INSPECTION PROCEDURE

NOTICE:
The smart key system (for entry function) uses a LIN communication system and CAN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (Click here). Troubleshoot the smart key system (for entry function) after confirming that the communication system is functioning properly.

1.READ VALUE USING TECHSTREAM (ANSWER-BACK BUZZER FUNCTION)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Body Electrical / Main Body / Data List.

  1. Read the Data List according to the display on the Techstream.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Wireless Buzzer Resp
    Answer-back buzzer operation / ON or OFF
    Customization status displayed
    -

    Result:
    Result
    Proceed to
    Customize setting is ON.
    A
    Customize setting is OFF.
    B



B
PERFORM CUSTOMIZE SETTING (Proceed to Customize Parameters) (Click here)
A


2.PERFORM ACTIVE TEST USING TECHSTREAM
  1. Enter the following menus: Body Electrical / Main Body / Active Test.

  1. Perform the Active Test according to the display on the Techstream.

    Main Body (Main Body ECU (Multiplex Network Body ECU)) 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Wireless Buzzer
    Wireless door lock buzzer assembly
    ON/OFF
    -

    OK:
    Wireless door lock buzzer sounds.



NG
GO TO WIRELESS DOOR LOCK CONTROL SYSTEM (Proceed to No Answer-Back) (Click here)
OK

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)