Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › STEERING ANGLE SENSOR

STEERING ANGLE SENSOR > INSTALLATION

for Preparation Click here



1. INSTALL SPIRAL CABLE WITH STEERING ANGLE SENSOR
  1. Install the spiral cable with steering angle sensor .

    NOTICE:
    1. Do not replace the spiral cable with steering angle sensor with the auxiliary battery connected and the power switch on (IG).
    2. Do not rotate the spiral cable with steering angle sensor with the auxiliary battery connected and the power switch on (IG).
    3. Ensure that the steering wheel is installed and aligned straight when inspecting the steering angle sensor.
    4. Do not remove the steering angle sensor from the spiral cable.



2. INSTALL UPPER STEERING COLUMN COVER


    C206259
  1. Engage the 2 claws and 2 pins to install the upper steering column cover.



3. INSTALL LOWER STEERING COLUMN COVER

NOTICE:
If the lower steering column cover is installed in the incorrect order, it will not be possible to assemble the lower steering column cover.



    C206256
  1. Engage the 2 claws to install the lower steering column cover.



    C206253
  1. Engage the 4 claws.



    C206257
  1. Engage the 2 claws.

    HINT:
    Press the area around the claws to engage them.



4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD


5. ADJUST SPIRAL CABLE
  1. Check that the power switch is off.

  1. Check that the cable is disconnected from the negative (-) auxiliary battery terminal.

    CAUTION:
    Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.



    B226994
  1. Rotate the spiral cable counterclockwise slowly by hand until it stops.

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.



    B226995E01
  1. Rotate the spiral cable clockwise approximately 2.5 turns to align the marks.
    Text in Illustration 
    *1
    Alignment Mark

    NOTICE:
    Do not turn the spiral cable using the airbag wire harness.

    HINT:
    The spiral cable will rotate approximately 2.5 turns to both the left and right from the center.



6. INSTALL STEERING WHEEL ASSEMBLY


    C248390E01
  1. Align the matchmarks on the steering wheel assembly and steering main shaft.
    Text in Illustration 
    *1
    Matchmark

  1. Install the steering wheel assembly set nut.

    Torque:
    50 N*m{ 510 kgf*cm , 37 ft.*lbf }

  1. Connect the connectors to the spiral cable sub-assembly.



7. INSPECT STEERING WHEEL CENTER POINT


8. INSTALL STEERING PAD

HINT:
Refer to the procedure from Install Steering Pad (Click here).



9. CALIBRATE STEERING ANGLE SENSOR
(Click here)