POWER WINDOW CONTROL SYSTEM > Front Passenger Side Power Window Auto Up / Down Function does not Operate with Front Passenger Side Power Window Switch |

| 1.READ VALUE USING TECHSTREAM (P-Door Motor) |
Connect the Techstream to the DLC3.
Turn the power switch on (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / P-Door Motor / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| P Door P/W Auto SW | Front passenger side power window auto switch signal / ON or OFF | ON: Front passenger door power window auto switch operated OFF: Front passenger door power window auto switch not operated | - |
|
| ||||
| OK | |
| 2.PERFORM INITIALIZATION (for Front Passenger Side) |
Initialize the power window regulator motor assembly (for front passenger side) (Click here).
| NEXT | |
| 3.CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION) |
Check that the front passenger side door power window moves when the auto up and down function of the power window regulator switch assembly (for front passenger side) is operated (Click here).
|
| ||||
| OK | ||
| ||
| 4.INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Front Passenger Side) |
![]() |
Remove the power window regulator switch assembly (for front passenger side) (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 8 (AUTO) - 1 (GND) | Auto up or auto down position | Below 1 Ω |
| *1 | Component without harness connected (Power Window Regulator Switch Assembly (for Front Passenger Side)) |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (POWER WINDOW SWITCH - REGULATOR MOTOR) |
![]() |
Disconnect the power window regulator motor assembly (for front passenger side) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| N7-8 (AUTO) - N2-4 (AUTO) | Always | Below 1 Ω |
| N7-8 (AUTO) - Body ground | Always | 10 kΩ or higher |
| *1 | Front view of wire harness connector (to Power Window Regulator Switch Assembly (for Front Passenger Side)) |
| *2 | Front view of wire harness connector (to Power Window Regulator Motor Assembly (for Front Passenger Side)) |
|
| ||||
| OK | ||
| ||