Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › CERTIFICATION ECU

CERTIFICATION ECU > INSTALLATION

for Preparation Click here



1. INSTALL CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)


    B229308
  1. Engage the 2 craws and install the certification ECU (smart key ECU assembly).



2. INSTALL ECU INTEGRATION BOX RH


    E189828
  1. Install the ECU integration box with the 2 nuts and bolt.

    Torque:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }

  1. Engage the 3 clamps to connect the wire harness.

  1. Connect each connector.



3. INSTALL GLOVE COMPARTMENT DOOR ASSEMBLY


    B223650E01
  1. With the glove compartment door assembly opened approximately 55° from its closed position, engage the 2 hinges horizontally.
    Text in Illustration 
    *a
    Opened Approximately 55°
    *b
    Closed

    NOTICE:
    Engaging the hinges from the top will deform the hinges. Be sure to install the glove compartment door assembly horizontally.



    B223648E01
  1. Slightly bend the stoppers (A) and (B) in the directions indicated by the arrows in the illustration and engage the stoppers to install the glove compartment door assembly.
    Text in Illustration 
    *1
    Glove Compartment Door Stopper Sub-assembly
    *2
    Stopper

  1. Engage the claw and connect the glove compartment door stopper sub-assembly.



4. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY
  1. Connect each connector.

  1. Engage the guide and 3 claws to install the No. 2 instrument panel under cover sub-assembly.



5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).



6. INSTALL REAR NO. 3 FLOOR BOARD


    B227791
  1. Engage the 2 guides to install the rear No. 3 floor board.



7. INSTALL REAR DECK FLOOR BOX
  1. Install the rear deck floor box.



8. INSTALL REAR NO. 2 FLOOR BOARD (for Separate Type)


    B227788E01
  1. Engage the 3 guides <A>.

  1. Engage the 2 guides <B> and install the rear No. 2 floor board as shown in the illustration.



9. REGISTER KEY

NOTICE:
If the certification ECU (smart key ECU assembly) is replaced, register the key (Click here).