Home › Vehicle Interior › PRE-COLLISION › PRE-COLLISION SYSTEM

DTC    C1A01    Driving Support ECU

for Preparation Click here


DESCRIPTION

The driving support ECU uses the millimeter wave radar sensor and lane recognition camera sensor to detect obstacles in front of the vehicle.
Based on this information, the driving support ECU calculates the risk of a collision and operates the pre-collision system when it determines that the risk is high.

DTC No.
DTC Detection Condition
Trouble Area
C1A01
When the power switch is on (IG), the driving support ECU detects an internal malfunction for approx. 1 second.
Driving support ECU

INSPECTION PROCEDURE

1.CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
  1. Using the Techstream, enter the following menus: Body Electrical / Pre-Collision 2 / Trouble Codes.

  1. Clear the DTCs (Click here).

  1. Recheck for DTCs.

    OK:
    DTC C1A01 is not output.



NG
REPLACE DRIVING SUPPORT ECU (Click here)
OK

CHECK FOR INTERMITTENT PROBLEMS (SYMPTOM SIMULATION) (Click here)