Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM

DTC    P1615    Communication Error from Distance Control ECU to HV ECU

for Preparation Click here


DESCRIPTION

This DTC is stored when a communication error occurs between the driving support ECU and power management control ECU.

DTC No.
DTC Detection Condition
Trouble Area
P1615
All of the following conditions are met
(a) Power switch on (IG)
(b) Communication error between driving support ECU and power management control ECU for 0.5 seconds or more
  1. Driving support ECU
  2. Power management control ECU

WIRING DIAGRAM

Refer to DTC C1A40 .

INSPECTION PROCEDURE

1.READ OUTPUT DTC (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Enter the following menus: Powertrain / Radar Cruise / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC is output
    B



B
GO TO DTC CHART (Click here)
A


2.CHECK WHETHER DTC OUTPUT RECURS (DTC P1615)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC P1615 is output
    B



B
Go to step 3
A

USE SIMULATION METHOD TO CHECK (Click here)  

3.REPLACE DRIVING SUPPORT ECU
  1. Replace the driving support ECU (Click here).


NEXT


4.CHECK WHETHER DTC OUTPUT RECURS (DTC P1615)
  1. Connect the Techstream to the DLC3.

  1. Turn the power switch on (IG).

  1. Turn the Techstream on.

  1. Clear the DTCs (Click here).

  1. Turn the power switch off.

  1. Turn the power switch on (IG).

  1. Enter the following menus: Powertrain / Hybrid Control / Trouble Codes.

  1. Read the DTCs.

    Result:
    Result
    Proceed to
    DTC is not output
    A
    DTC P1615 is output
    B



B
REPLACE POWER MANAGEMENT CONTROL ECU (Click here)
A

END