DTC
P0120 Throttle / Pedal Position Sensor / Switch "A" Circuit Malfunction | |
DTC
P0121 Throttle / Pedal Position Sensor / Switch "A" Circuit Range / Performance Problem |
DTC
P0122 Throttle / Pedal Position Sensor / Switch "A" Circuit Low Input |
DTC
P0123 Throttle / Pedal Position Sensor / Switch "A" Circuit High Input |
DTC
P0220 Throttle / Pedal Position Sensor / Switch "B" Circuit |
DTC
P0222 Throttle / Pedal Position Sensor / Switch "B" Circuit Low Input |
DTC
P0223 Throttle / Pedal Position Sensor / Switch "B" Circuit High Input |
DTC
P2135 Throttle / Pedal Position Sensor / Switch "A" / "B" Voltage Correlation |
DTC No.
| DTC Detection Condition
| Trouble Area
|
P0120
| The output voltage of VTA1 quickly fluctuates beyond the lower and upper malfunction thresholds for 2 seconds or more (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- ECM
|
P0121
| The difference between the VTA1 and VTA2 voltages is less than 0.8 V, or higher than 1.6 V for 2 seconds (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- Throttle position sensor circuit
- ECM
|
P0122
| The output voltage of VTA1 is 0.2 V or less for 2 seconds or more (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- Short in VTA1 circuit
- Open in VCTA circuit
- ECM
|
P0123
| The output voltage of VTA1 is 4.54 V or higher for 2 seconds or more (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- Open in VTA1 circuit
- Open in ETA circuit
- Short between VCTA and VTA1 circuits
- ECM
|
P0220
| The output voltage of VTA2 quickly fluctuates beyond the lower and upper malfunction thresholds for 2 seconds or more (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- ECM
|
P0222
| The output voltage of VTA2 is 1.75 V or less for 2 seconds or more (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- Short in VTA2 circuit
- Open in VCTA circuit
- ECM
|
P0223
| The output voltage of VTA2 is 4.8 V or higher, and VTA1 is between 0.2 V and 2.02 V for 2 seconds or more (1 trip detection logic).
| - Throttle position sensor (built into throttle body with motor assembly)
- Open in VTA2 circuit
- Open in ETA circuit
- Short between VCTA and VTA2 circuits
- ECM
|
P2135
| Either of the following conditions is met (1 trip detection logic): (a) The difference between the output voltages of VTA1 and VTA2 is 0.02 V or less for 0.5 seconds or more. (b) The output voltage of VTA1 is 0.2 V or less, and VTA2 is 1.75 V or less for 0.4 seconds or more.
| - Short between VTA1 and VTA2 circuits
- Throttle position sensor (built into throttle body with motor assembly)
- ECM
|