DTC P2102 Throttle Actuator Control Motor Circuit Low |
DTC P2103 Throttle Actuator Control Motor Circuit High |
| DTC No. | DTC Detection Condition | Trouble Area |
| P2102 | Both of the following conditions continue for 2.0 seconds (1 trip detection logic): (a) The throttle actuator drive duty cycle is 80% or higher. (b) The throttle actuator current is less than 0.5 A. |
|
| P2103 | Either of the following conditions is met (1 trip detection logic):
|
|
| Required Sensors/Components | Throttle actuator (throttle body with motor assembly) |
| Frequency of Operation | Continuous |

| Tester Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|

| 1.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (RESISTANCE OF THROTTLE ACTUATOR) |
Inspect the throttle body with motor assembly (Click here).
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (THROTTLE BODY WITH MOTOR ASSEMBLY - ECM) |
Disconnect the throttle body with motor assembly connector.
Disconnect the ECM connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C12-2 (M+) - C10-60 (M+) | Always | Below 1 Ω |
| C12-1 (M-) - C10-30 (M-) | Always | Below 1 Ω |
| C12-2 (M+) or C10-60 (M+) - Body ground | Always | 10 kΩ or higher |
| C12-1 (M-) or C10-30 (M-) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| C12-2 (M+) - C9-60 (M+) | Always | Below 1 Ω |
| C12-1 (M-) - C9-30 (M-) | Always | Below 1 Ω |
| C12-2 (M+) or C9-60 (M+) - Body ground | Always | 10 kΩ or higher |
| C12-1 (M-) or C9-30 (M-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 3.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (VISUALLY CHECK THROTTLE VALVE) |
Check for foreign objects between the throttle valve and the housing.
|
| ||||
| OK | |
| 4.INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (THROTTLE VALVE) |
Check if the throttle valve opens and closes smoothly.
|
| ||||
| OK | ||
| ||