Home › Suspension › TIRE PRESSURE MONITORING › TIRE PRESSURE WARNING SYSTEM

TIRE PRESSURE WARNING SYSTEM > TC and CG Terminal Circuit

for Preparation Click here


DESCRIPTION

Tire pressure warning system DTCs can be checked by connecting terminals 13 (TC) and 4 (CG) of the DLC3. The DTCs are indicated by blinking the tire pressure warning light.

WIRING DIAGRAM


C307802E04


INSPECTION PROCEDURE

1.CHECK CAN COMMUNICATION SYSTEM
  1. Check if CAN communication system DTCs are output (Click here).

    Result:
    Result
    Proceed to
    DTCs are not output.
    A
    DTCs are output.
    B



B
GO TO CAN COMMUNICATION SYSTEM (Click here)
A


2.CHECK DTC (C2179/79)
  1. Check if DTC C2179/79 is output (Click here).

    Result:
    Result
    Proceed to
    DTC C2179/79 is not output.
    A
    DTC C2179/79 is output.
    B



B
GO TO DTC C2179/79 (Click here)
A


3.CHECK HARNESS AND CONNECTOR (TC of DLC3 - ECM AND HYBRID VEHICLE CONTROL ECU ASSEMBLY)
  1. Disconnect the A40 ECM connector.

  1. Disconnect the G81 hybrid vehicle control ECU assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G4-13 (TC) - A40-23 (TC)
    Always
    Below 1 Ω
    G4-13 (TC) - G81-28 (TC)
    Always
    Below 1 Ω
    G4-13 (TC), A40-23 (TC) or G81-28 (TC) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.CHECK HARNESS AND CONNECTOR (CG of DLC3 - BODY GROUND)


    C271000E14
  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G4-4 (CG) - Body ground
    Always
    Below 1 Ω

    Text in Illustration 
    *a
    Front view of DLC3



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)