FRAME WIRE > REMOVAL |
| 1. PRECAUTION |
| 2. REMOVE INVERTER WITH CONVERTER ASSEMBLY |
| 3. REMOVE INVERTER BRACKET ASSEMBLY |
![]() |
Remove the bolt and separate the motor cable protector.
![]() |
Disconnect the 2 wire harness clamps.
![]() |
Remove the 2 bolts and separate the inverter reservoir tank assembly.
![]() |
Remove the bolt and disconnect the earth wire.
![]() |
Remove the 4 bolts and inverter bracket assembly.
| 4. REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
| 5. REMOVE REAR SEAT CUSHION ASSEMBLY (for Separate Type Seatback) |
![]() |
Disengage the 2 clips.
| *a | RH Side |
| *b | LH Side |
![]() |
Disengage the hook of the rear seat cushion assembly from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 6. REMOVE REAR SEAT CUSHION ASSEMBLY (for Bench Type Seatback) |
![]() |
Using a clip remover, disengage the 2 clips.
| *a | for RH Side |
| *b | for LH Side |
![]() |
Disengage the 2 rear seat cushion lock hooks of the rear seat cushion assembly from the vehicle body as shown in the illustration.
| a | 100 mm (3.94 in.) or less |
![]() |
Choose a hook to disengage first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to disengage the hook.
| *a | Hook |
Repeat the step above for the other hook.
Remove the rear seat cushion assembly.
| 7. REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY |
![]() |
Remove the 4 bolts and rear seat cushion leg sub-assembly.
| 8. REMOVE NO. 1 HYBRID BATTERY EXHAUST DUCT |
![]() |
Remove the clip and No. 1 hybrid battery exhaust duct.
| 9. REMOVE BATTERY COOLING BLOWER ASSEMBLY |
![]() |
Disconnect the battery cooling blower assembly connector and clamp.
![]() |
Remove the 2 bolts, nut and battery cooling blower assembly.
| 10. REMOVE NO. 1 HYBRID VEHICLE BATTERY COVER PANEL LH |
![]() |
Using the service plug grip, remove the battery cover lock striker.
| *1 | Service Plug Grip |
| *2 | Battery Cover Lock Striker |
| *3 | Button |
| *a | Projection |
| *b | Turn |
Remove the 4 nuts and No. 1 hybrid vehicle battery cover panel LH.
| 11. DISCONNECT CABLE FROM POSITIVE AUXILIARY BATTERY TERMINAL |
![]() |
Remove the connector cover.
![]() |
Remove the nut and disconnect the positive auxiliary battery terminal.
| 12. REMOVE FRAME WIRE |
![]() |
Disconnect the connector.
![]() |
Disconnect the 2 connectors.
| *1 | Shielded Wire Ground |
Disconnect the shielded wire ground.
![]() |
Disconnect the 6 clamps.
![]() |
Disengage the claw and disconnect the frame wire from the engine room junction block assembly.
![]() |
Disconnect the clamp.
![]() |
Disconnect the clamp.
![]() |
Disconnect the clamp.
![]() |
Disconnect the clamp.
Remove the 3 nuts.

Disconnect the 4 clamps and remove the frame wire.