SFI SYSTEM > VC Output Circuit |


| 1.CHECK MIL |
Check that the Malfunction Indicator Lamp (MIL) lights up when the power switch is turned on (IG).
|
| ||||
| OK | ||
| ||
| 2.CHECK COMMUNICATION BETWEEN INTELLIGENT TESTER AND ECM |
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG).
Turn the tester on.
Check the communication between the tester and ECM.
| Result | Proceed to |
| Communication is not possible | A |
| Communication is possible | B |
|
| ||||
| A | |
| 3.CHECK MIL (THROTTLE POSITION SENSOR) |
Disconnect the throttle body with motor assembly connector.
Turn the power switch on (IG).
Check the MIL.
| Result | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 4.CHECK MIL (MANIFOLD ABSOLUTE PRESSURE SENSOR) |
Disconnect the manifold absolute pressure sensor connector.
Turn the power switch on (IG).
Check the MIL.
| Result | Proceed to |
| MIL does not illuminate | A |
| MIL illuminates | B |
|
| ||||
| A | |
| 5.CHECK HARNESS AND CONNECTOR |
Disconnect the throttle body with motor assembly connector.
Disconnect the manifold absolute pressure sensor connector.
Disconnect the ECM connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| C10-115 (VCTA) - Body ground | Always | 10 kΩ or higher |
| C10-118 (VCPM) - Body ground | Always | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
| C9-115 (VCTA) - Body ground | Always | 10 kΩ or higher |
| C9-118 (VCPM) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||