FUEL INJECTOR > REMOVAL |
| 1. PRECAUTION |
| 2. DISCHARGE FUEL SYSTEM PRESSURE |
| 3. REMOVE FRONT FLOOR COVER RH |
![]() |
Using a clip remover, remove the 2 clips <A>.
Disengage the 3 clips <B>.
![]() |
Disengage the 3 guides and remove the front floor cover RH.
| 4. DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL |
| 5. REMOVE EGR VALVE WITH COOLER ASSEMBLY |
| 6. SEPARATE BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (for RHD) |
![]() |
Remove the 2 nuts and separate the brake master cylinder reservoir assembly from the reservoir bracket.
| 7. REMOVE NO. 1 IGNITION COIL |
![]() |
Disconnect the 4 No. 1 ignition coil connectors.
Remove the 4 bolts and 4 No. 1 ignition coils.
| 8. SEPARATE ENGINE WIRE (for LHD) |
![]() |
Disconnect the 4 injector connectors.
![]() |
Disconnect the wire harness clamp.
Remove the 3 bolts and separate the engine wire.
| 9. SEPARATE ENGINE WIRE (for RHD) |
![]() |
Disconnect the 4 injector connectors.
![]() |
Remove the 3 bolts and separate the engine wire.
| 10. REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY |
![]() |
Disconnect the No. 1 ventilation hose and No. 2 ventilation hose.
![]() |
Remove the 9 bolts, 2 seal washers, 2 nuts and cylinder head cover sub-assembly.
Remove the gasket from the cylinder head cover sub-assembly.
| 11. REMOVE EFI FUEL PIPE CLAMP |
![]() |
Remove the EFI fuel pipe clamp.
| 12. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Pinch the retainer of the fuel tube connector, and then pull the fuel tube connector off of the fuel delivery pipe.
| *1 | Fuel delivery pipe |
| *2 | Fuel Tube Connector |
| *3 | Nylon Tube |
| *4 | O-ring |
| *5 | Retainer |
![]() | Pinch |
![]() | Pull |
| 13. REMOVE FUEL DELIVERY PIPE |
![]() |
Remove the bolt.
![]() |
Disengage the clamp to disconnect the wire harness.
Remove the 2 bolts and the fuel delivery pipe with the 4 fuel injectors.
| 14. REMOVE FUEL DELIVERY SPACER |
![]() |
Remove the 2 fuel delivery spacers from the cylinder head.
| 15. REMOVE INJECTOR VIBRATION INSULATOR |
![]() |
Remove the 4 injector vibration insulators from the cylinder head.
| 16. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Pull the 4 fuel injector assemblies out of the fuel delivery pipe.
![]() | Pull |
Remove the O-ring from each fuel injector.
For reinstallation, attach a tag or label to each injector shaft.