FUEL PUMP > INSTALLATION |
| 1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY |
![]() |
Install a new fuel suction tube set gasket onto the fuel tank as shown in the illustration.
| *1 | Fuel Suction Tube Set Gasket |
![]() |
Set the fuel suction tube with pump and gauge assembly to the fuel tank.
| *a | Protrusion |
| *b | Notch |
Align the protrusions of the fuel suction tube with pump and gauge assembly with the notches of the fuel tank.
| 2. INSTALL FUEL PUMP GAUGE RETAINER |
![]() |
While holding the fuel suction tube assembly with pump and gauge by hand to prevent it from tilting, align the mark on a new fuel pump gauge retainer with the start mark on the fuel tank and tighten the fuel pump gauge retainer 180° by hand.
| *a | Start Mark |
| *b | Mark |
| *c | Front |
![]() |
Temporarily install the SST plate and claws to the fuel pump gauge retainer.
| *1 | SST (Plate) |
| *2 | SST (Claw) |
| *3 | Rib |
While pressing the claws of SST to the fuel pump gauge retainer ribs securely, tighten the bolts.
Install the SST handle.
![]() |
Tighten the fuel pump gauge retainer approximately 360° so that the mark on the retainer comes within the range shown in the illustration.
| *1 | SST (Handle) |
| *2 | SST (Plate) |
| *3 | SST (Claw) |
| *a | Mark |
| *b | Front |
| 3. CONNECT NO. 1 CANISTER OUTLET HOSE SUB-ASSEMBLY |
![]() |
Connect the No. 1 charcoal canister outlet hose to the fuel suction tube with pump and gauge assembly.
| 4. CONNECT NO. 2 FUEL EMISSION TUBE |
![]() |
Connect the No. 2 fuel emission tube to the fuel suction tube with pump and gauge assembly with the clip.
| 5. CONNECT FUEL TANK MAIN TUBE SUB-ASSEMBLY |
![]() |
Push the fuel tube joint in the plug of the fuel suction plate, then install the tube joint clip.
| *1 | Tube Joint Clip |
| *2 | Fuel Tube Joint |
| *3 | O-ring |
| *4 | Collar |
| *a | CORRECT |
| *b | INCORRECT |
Connect the fuel pump connector.
| 6. CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL |
| 7. INSPECT FOR FUEL LEAK |
Check fuel pump operation.
Connect the intelligent tester to the DLC3.
Turn the power switch on (IG) and turn the intelligent tester on.
Enter the following menus: Powertrain / Engine and ECT / Active Test / Control the Fuel Pump / Speed.
Check for pressure in the fuel inlet tube from the fuel line. Check that sounds of fuel flowing from the fuel tank can be heard. If no sounds can be heard, check the integration relay, fuel pump, ECM and wiring connectors.
Inspect for fuel leaks.
Check that there are no fuel leaks from the fuel system after doing any maintenance or repairs. If there is a fuel leak, repair or replace parts as necessary.
Turn the power switch off.
Disconnect the intelligent tester from the DLC3.
| 8. INSTALL REAR FLOOR SERVICE HOLE COVER |
![]() |
Install the rear floor service hole cover with new butyl tape.
| 9. INSTALL CROSS ANCHOR BRACKET SUB-ASSEMBLY |