DTC C1511/11 Torque Sensor 1 Malfunction |
DTC C1512/12 Torque Sensor Circuit Malfunction |
DTC C1513/13 Torque Sensor Circuit Malfunction |
DTC C1514/14 Torque Sensor Power Source Circuit Malfunction |
DTC C1517/17 Torque Sensor Hold Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| C1511/11 | Torque sensor malfunction |
|
| C1512/12 | ||
| C1513/13 | ||
| C1514/14 | ||
| C1517/17 |

| 1.CHECK CONNECTOR CONNECTION CONDITION |
Check the connection condition of the torque sensor connector.
|
| ||||
| OK | |
| 2.CHECK POWER STEERING ECU ASSEMBLY (TRQV VOLTAGE) |
![]() |
Turn the power switch on (ready).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| z7-8 (TRQV) - body ground | Power switch on (ready) | 4.5 to 5.5 V |
| *a | Component with harness connected (Power Steering ECU Assembly) |
|
| ||||
| OK | |
| 3.CHECK POWER STEERING ECU ASSEMBLY (TRQ1, TRQ2 VOLTAGE) |
![]() |
Turn the power switch on (ready).
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition (Steering Wheel Position) | Specified Condition |
| z7-9 (TRQ1) - Body ground | Power switch on (ready) (Center position) | 2.3 to 2.7 V |
| z7-1 (TRQ2) - Body ground | Power switch on (ready) (Center position) | 2.3 to 2.7 V |
| z7-9 (TRQ1) - Body ground | Power switch on (ready) (Turned to right) | 2.5 to 3.8 V |
| z7-1 (TRQ2) - Body ground | Power switch on (ready) (Turned to right) | 1.2 to 2.5 V |
| z7-9 (TRQ1) - Body ground | Power switch on (ready) (Turned to left) | 1.2 to 2.5 V |
| z7-1 (TRQ2) - Body ground | Power switch on (ready) (Turned to left) | 2.5 to 3.8 V |
Under each condition, measure the voltage at terminals TRQ1 and TRQ2, and calculate the sum.
| Inspection Item | Condition (Steering Wheel Position) | Specified Condition |
| Sum of voltage between z7-9 (TRQ1) and body ground and voltage between z7-1 (TRQ2) and body ground | Power switch on (ready) Steering wheel not being turned (without load) | Between 4.75 V and 5.25 V |
| Power switch on (ready) Steering wheel being turned to the right with vehicle stopped | ||
| Power switch on (ready) Steering wheel being turned to the left with vehicle stopped |
| *a | Component with harness connected (Power Steering ECU Assembly) |
|
| ||||
| OK | ||
| ||