Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Removable Headrest)

FRONT SEAT SIDE AIRBAG ASSEMBLY (w/ Removable Headrest) > REMOVAL

for Preparation Click here


CAUTION:
  1. Be sure to read Precaution thoroughly before servicing (Click here).
  2. Wear protective gloves. Sharp areas on the seat frame and adjuster may injure your hands.
  3. If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with the necessary parts in accordance with the extent of the collision damage (Click here).

HINT:
Use the same procedure for the LH side and RH side.



1. REMOVE FRONT SEAT ASSEMBLY
(Click here)


2. DISCONNECT SEPARATE TYPE FRONT SEATBACK COVER


    B299149
  1. Disconnect the rubber band of the separate type front seatback cover.



3. SEPARATE FRONT SEAT AIRBAG ASSEMBLY


    B301352
  1. Disengage the fastener and separate the front seat airbag assembly wire harness.



  1. for LH Side:



      B296414
    1. Disengage the claw and 6 clamps to separate the front seat airbag assembly wire harness.



  1. for RH Side:



      B296413
    1. Disengage the claw and 3 clamps to separate the front seat airbag assembly wire harness.



4. REMOVE SEPARATE TYPE FRONT SEATBACK COVER WITH PAD


    B299151
  1. Remove the 5 hog rings.



    B301367
  1. Remove the 3 hog rings.



  1. Type B:



      B386949
    1. Remove the 2 hog rings.



    B301369
  1. Turn back the separate type front seatback cover.



    B299158
  1. Remove the 2 nuts and the 3 brackets.



    B296379
  1. Disengage the 4 claws and remove the 2 front seat headrest supports.

  1. Remove the separate type front seatback cover with pad.



5. REMOVE FRONT SEAT AIRBAG ASSEMBLY


    B300261
  1. Disengage the 2 clamps.

  1. Remove the 2 nuts and the front seat airbag assembly.

    CAUTION:
    1. The nuts must not be reused.
    2. Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.