Home › Vehicle Interior › HEATING / AIR CONDITIONING › AMBIENT TEMPERATURE SENSOR
RM3210E _58 Vehicle Interior _047534 HEATING / AIR CONDITIONING _0230759 AMBIENT TEMPERATURE SENSOR A

HEATING / AIR CONDITIONING  AMBIENT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during ambient temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle (w/ TOYOTA Parking Assist-sensor System)

·

Ultrasonic sensor detection angle registration (w/ TOYOTA Parking Assist-sensor System)


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control modes and/or perform initialization (w/ Exhaust Heat Recirculation System) Grille Shutter system (Click here)

PROCEDURE

Hide 53289A 1.REMOVE RADIATOR SUPPORT OPENING COVER (w/o Exhaust Heat Recirculation System)

Hide 2.REMOVE FRONT BUMPER ASSEMBLY (w/ Exhaust Heat Recirculation System)

Hide 88790B 3.REMOVE THERMISTOR ASSEMBLY (w/o Exhaust Heat Recirculation System)

a.
E338136

Disengage the clamp.


b.

Disconnect the connector to remove the thermistor assembly.


Hide 88790B 4.REMOVE THERMISTOR ASSEMBLY (w/ Exhaust Heat Recirculation System)

a.
E338138

Disengage the clamp.


b.

Disconnect the connector to remove the thermistor assembly.