Home › Vehicle Exterior › LIGHTING (EXT) › HEADLIGHT ASSEMBLY
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231469 HEADLIGHT ASSEMBLY A

LIGHTING (EXT)  HEADLIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control modes and/or perform initialization Grille Shutter system (Click here)
No. 1 headlight ECU sub-assembly LH
·

Synchronize vehicle information

·

Initialize No. 1 headlight ECU sub-assembly LH


Automatic headlight beam level control system (Click here)

NOTICE:

If the headlight assembly RH is replaced with a new one, vehicle information registration and initialization are not necessary.


HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 2.REMOVE HEADLIGHT ASSEMBLY

a.
E336981C01
0,0 0,0 false
V113147

Remove in this Direction


Disengage the clip to separate the cover as shown in the illustration.


b.
E336982C01
0,0 0,0 false
V100155

Protective Tape


Apply protective tape around the headlight assembly as shown in the illustration.


c.
E336983

Disconnect the connector.


d.
E336984C01
1.146,2.854 1.208,3.031 true 2.865,2.948 2.927,3.125 true 2.948,3.031 3.26,3.229 0.313,0.198 10 true *a 1.146,3.031 1.458,3.229 0.313,0.198 10 true *a
*a Connector Lock Lever
V113147

Disconnect in this Direction


Disengage the claw, pull down the connector lock lever as shown in the illustration and disconnect the connector.


e.
E336986C01
0.906,0.479 1.219,0.677 0.313,0.198 10 true *b 1.594,1.188 1.906,1.385 0.313,0.198 10 true *b 2.792,0.333 3.104,0.531 0.313,0.198 10 true *b 2.896,1.917 3.208,2.115 0.313,0.198 10 true *a
*a Bolt
*b Screw


Remove the bolt and 3 screws.


f.
E336987C01
0,0 0,0 false
V113147

Remove in this Direction


Remove the headlight assembly as shown in the illustration.