Home › Vehicle Exterior › LIGHTING (EXT) › FOG LIGHT ASSEMBLY
RM3210E _59 Vehicle Exterior _047533 LIGHTING (EXT) _0231470 FOG LIGHT ASSEMBLY A

LIGHTING (EXT)  FOG LIGHT ASSEMBLY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fog light assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly
·

Ultrasonic sensor detection angle

·

Ultrasonic sensor detection angle registration


·

Intelligent clearance sonar system

·

Simple advanced parking guidance system


(Click here)
Change grille shutter control modes and/or perform initialization Grille Shutter system (Click here)

HINT:
·

Use the same procedure for the RH side and LH side.

·

The following procedure is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT BUMPER ASSEMBLY

Hide 81220 2.REMOVE FOG LIGHT ASSEMBLY

a.
E337012

Disengage the clamp.


b.

Remove the 3 screws and fog light assembly.